TeamSwift

16 valve SOHC camshaft specs

Superfly...i've checked cam specs on Esteem 1.6, and Swift 1.3 16 valve SOHC engines, and found them to be almost identical. You've said the 1.6 tracker/Geo (truck) engine has a different cam, do you recall how different it is?

Darcy

What are you up to now?

_________________
Contact 3tech: [email protected]

I'm just gathering parts for further testing, and wondering if i should grab the cam from a truck engine before it's too cold to go outside....Brrrr, Winterpeg!
I will probably post a lot of dyno results of Turbo Suzuki engine testing starting in January.
Darcy

Stop fooling around and put a real cam in that thing.

_________________
Contact 3tech: [email protected]

I have a few different versions of real cams...all for the twin cam head...and for the moment, i'm having some single cam fun! ...yes, it'd be nice to have a better cam for the SOHC too, and know that you're more than up to the task, but i've put such huge effort into a real twin cam project, that i can't justify spending a lot on the single cam, just to put it in the corner as a spare.

let me know how that truck cam works out for you.

trucks have a distributor drive gear on the back instead of the trigger for the CMP.

_________________
98 swift 1.6 16v swap
03 cobra bolt ons
97 3000gt vr4 e85, high comp, bolt ons
too many others to list

So, for more low end vacuum, for throttle response and pulling power, for a 1993 Tracker G16A, I should source a G13A cam?
Distributor that would be compatible with that would be....?
Can said cam and distributor be utilized w/removing the existing low mile head?

Going to premium gasoline is no problem, that might be the only downside I can see. (cyl Press)

I'm new here, and new to the brand, but I do know what I am doing in a general sense of modding and cam specs.

who does regrinds for G16a's? Looking for more lift, less dur. (Yeah, I'm weird...lol)

id like 2 know also.

_________________
wish i had a car like runbag, wonder if he would help me build 1?

_________________
Contact 3tech: [email protected]

Is the reground camshaft for the G13B (distributor type) and G16B (distributorless type) the same one?

I generally grind the same profiles on both of them.

_________________
Contact 3tech: [email protected]

What I meant is, can a cam from a G13B head be used in a G16B head? Does it require any modifications to be made given that the G16B is distributorless? In India I have heard some tuners say that the end bit of the cam that houses the connection to the distributorless type can be swapped from the G13B's to the G16B's and can be used on the Baleno. Wanted to know if such a thing is possible or not.

If the G16 is dist-less, then they are the same cam.

_________________
Contact 3tech: [email protected]

Yes the G16B we get here is Distributorless type. Whereas the G13B we get in India is distributor type. So was wondering how they could use a cam from a distributor type engine and use the same on a distributorless type setup.

You can't do it without a lot of work.

_________________
Contact 3tech: [email protected]

Yes I know its an old thread....
But does anyone know the rocker ratio on the sohc 16v 1.6 ?

Give or take, about 1.5. The numbers listed are gross lift, so the lobe dimensions would be the lift divided by 1.5.

_________________
Contact 3tech: [email protected]

Thank you. Just to clarify, this wouldnt apply to both ex and in though would it ?

Why not?

_________________
Contact 3tech: [email protected]