TeamSwift

hi guy's and girl's,
this is the cylinder head I'm going to be using for the turbo motor.

hi guy's and girl's,
I've finished off the flat floor cover that I made from a old roller bind.
and the extra 3 gauges for the dash.

hello guy's and girl's
I received my hub centric rings and fitted some service parts.




still waiting on parts from ebay

hello guy's and girl's,
still preparing to replace the motor and box, but doing some swaps from my old car
to this one.
the coolant is why it's getting a motor swap.



the old motor/ new turbo motor, when done.


I'll keep you posted

Good work I love the clock.

hello again guy's and girl's,
thx RP91gt

this is the motor that is going to be going in until I build the turbo motor.

Hello guy's and girl's,
The front end suspension rebuild is done, but
I'm wait on some seals before doing the motor swap.

hello guy' and girl's,
today was the day for the motor swap











went well just need to finish off ac and a few things before it's on the road

hello guy's and girl's,
I decided to add a Usb port to the dash surround.
I used a cigarette lighter socket and a adaptor for usb power.






I still have to install it back in the car and wire it

Hello Guy's and Girl's,
this is a flow up.
this hole was widened to fit the usb cable.








this is the start of the turbo motor.

hello guy's and girl's,
I have now got the last of my parts or a new project, I'm not sure yet.
It has a few problems.

hi guy's and girl's,
I've decided to restore the Gti to it's former glory.
I'll keep you posted.

Hello guy's and girl's,
I've started to work on a front lip, it's a upper front bumper.









still need a lot of work but it's a start

hello guy's and girl's,
I have been working on the front bumper, first was to fill in the gap with foam.
then to put some fiberglass over the top.









i'll keep you posted

hello guy's and girl's,





this was the 2nd step of fiberglass work, next is to shape and final glassing.

hello guy's and girl's,
I have been waiting for the fiberglass to fully set before sanding it into shape.
and I have started to fill in the low spots with a bit of bog.





and the process continues, a lot more to go yet.

Looking good man.

_________________
1994 Suzuki Swift GA SOHC. 4/5
Vogtland lowering coils
Ngk plugs
8mm silicon wires.

Are you going to upgrade the carburetor?

_________________
1994 Suzuki Swift GA SOHC. 4/5
Vogtland lowering coils
Ngk plugs
8mm silicon wires.

hey guy's and girl's,
I don't plain to upgrade the carby at this stage but I do intend to upgrade to efi still.
thanks BikeAmusPrime

Hello guy's and girl's,

this is the progress I have made










Here is a couple of photos I have for the 8v cylinder head.
Inlet port

exhaust port

the straw is in a coolant passage near the exhaust port.


I hope this helps

Hi guy's and girl's,
Just a quick update still working on my front bumper.
A old friend finished my lower front brace.

Iv'e been following this with interest, keep it up and thanks for the photo's

Hi guy's and girl's,
The bumper is back on the car for final steps.




hey thank Zammo

hello guys and gilrs,
the front bumper has had it's final shaping, and now it's time for body work and paint.
the motor is coming alone in it's mockup stage.

Hello boys and girls,
I had the cylinder head sent out for a stock rebuild.
It's taken awhile but i have finished building my ecu, this is the cheapest form of ecu i've seen.







I've started the body work.