TeamSwift

Anyone know the original Suzuki part number for the internal seal on the Swift distributor shaft seal? Not talking about the o-ring at the bottom. Need the one that is actually internal that keeps the oil from getting inside of the distributor. Please, no aftermarket number, thanks.

For the DOHC motor? If so I have a rebuild kit. Bearing and seals.

Mine is the 3. I was looking for that inner seal that stops the oil from seeping inside the distributor itself. Not the o-ring on the outer shaft.

AEO25SK is what I can see on the one in the bottom of my 3 cyl vacuum advance dizzy.

_________________
"If you think education is expensive, try ignorance." - Derek Bok


1990 geo metro 1.0 5 speed 3-door hatchback "herbie"
1990 geo metro 1.0 5 speed convertible "sportie"

this is a picture of a rebuild kit a Suzuki dealer sent me. The seal I am looking for is circled.

Yea, the 3cyl is different.

The 95 and up seals are all the same.
The early vaccum advance distributors and the
pre ODB1 distributors have a much larger seal bearing and shaft.
Some of the ODB1 distributors aare the same as the 95 and up
Bottom line.... There are 3 different shaft seals and bearings used.
I build distributors all the time.
Just curious but what did the suzuki kit cost you?

_________________
Fainya
97 Geo Metro LSI,1.3L-GT-DOHC-16v,4.10 5-speed,A/C,170,000,suspension lowered 1",4 wheel disk brakes,15"alloy wheels with 185/50-15 Toyo's,GT bucket seats,analog oil pressure gauge,cruise control, new paint job. 40 mpg at 65 mph.
Good, fast, cheap. You only get two.

Actually didn't buy it. The dealer said the kit wasn't available any longer. He said it was a picture found in the computer for a 3 cyl Suzuki.